Installation, repair and maintenance of radiant floor heating for homes and businesses. We look at the system on site, including the boiler, manifolds, tubing and controls, and quote the work before we start.
Serving Alamo, Albany, Berkeley, Blackhawk, Concord, Danville, Diablo, Dublin, El Cerrito, Lafayette, Moraga, Orinda, Pleasant Hill, Pleasanton, Richmond, San Francisco, San Ramon and Walnut Creek.
Request an estimate
Tell us about the job and we'll call or text you back to talk it through and set up a time.
Request an estimateNeed help right away?
Call (925) 272-1570 Text usSigns your radiant floor needs attention
- One room or zone stays cold
- Floors take much longer to warm up than they used to
- The boiler or heat source runs all the time
- System pressure keeps dropping, or there's water near the manifold
- A thermostat no longer controls its zone
What we work on
- New hot-water radiant floor installations
- Repairs to existing radiant floor systems
- Manifolds, zone valves and circulator pumps
- Connections to the boiler or water heater
- Thermostats and zone controls
- Air in the lines and balancing between zones
What to expect
- We talk through the problem by phone or text first, so we come prepared.
- On site, we look at the system and find the cause, not just the symptom.
- We explain what it needs in plain language and give you a clear price before any work starts.
- Once you approve the quote, we do the work and test it before we leave.
Common questions
Can radiant floor heating be added to an existing home?
Often, yes, especially during a remodel or when new flooring is going in. It depends on the floor, the space underneath and your heat source. We'll look at your home and tell you what's possible.
Why is one zone cold?
Common causes are air in the lines, a stuck zone valve, a failing pump or a thermostat problem. We check each part of the system to find which one it is.
